I tried looking up the axle measurements for your 2018 KZ Sportsmen Classic 130RB travel trailer but I wasnt' able to locate any specs so the only option I can confidently recommend is the Timbren Axle-Less Suspension system with a lift like part # ASR2KHDS04 which is rated for 2,000 lbs and has a 4" lift. For a more standard axle recommendation I'll need to know your hub face (A) and spring seat (B) measurements that you can see in the attached photo. view full answer...
Sounds like you're needing the Replacement Key for Global Link RV Locks - 341 - # 295-000067. This is the same brand and key number as what you have so it'll be perfect for your 2018 KZ Sportsmen. view full answer...
Sure we have plenty of replacement caps for RAM jacks, however I would need a bit more information to get you the right cap.
For instance, if you had a TJA-2000S series jack then you could use the Replacement Cap for etrailer and Ram Sidewind A-Frame Jacks # TJA-2000S-CP.
If you want to let me know a bit more of what you're working with I'd love to get you in the right direction. view full answer...
For replacement arms that fit in place of your 63" tall Solera awning arms we have the Solera Classic Universal Awning Support Arms for RVs which come both in Black # LC434715 and White # LC434716.
If you weren't needing the entire kit, go ahead and send me a photo of the part you're needing to replace so I can double check that with what's available. view full answer...
If it feels like the hubs are getting too hot, one item to check is if the spindle nut is too tight and the added stress on the bearings is overheating the bearings and hub that could cause damage to the bearings. I have attached a video of our technician installing a hub on a trailer and how the spindle nut should be tightened to prevent over heating. At the 1 minute and 45 second mark you can see the hub installation.
You also will want to try adjusting your brakes since it's possible... view full answer...
For the Solera XL 12 volt awning part # LCV000334909-362243 that you referenced we have replacement arms with the part # LC362243 which would be all that you'd need. view full answer...
The studs on your AL-KO drum should have a 1/2" diameter like the Kodiak # K12WB2 but you will need to filter through the attached link of wheel bolts to find the one that matches your stud length. These are filtered by total length but you can click on each individual page to see the length of the threaded portion to match your application. view full answer...